Lifting Switch (Front) Circuit Inspection
WARNING: This page is about a different car, the 2006 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FUNCTION
With CONSULT-II
With "LIFT FR SW-UP, LIFT FR SW-DN" on the DATA MONITOR, operate the lifting switch (front) to check ON/OFF operation.
MONITOR ITEM CONTENTSMonitor item [OPERATION or UNIT] Contents LIFT FR SW-DN "ON/OFF" ON/OFF status judged from the FR lifter switch (DOWN) signal is displayed. LIFT RR SW-UP "ON/OFF" ON/OFF status judged from the RR lifter switch (UP) signal is displayed. Without CONSULT-II
- Turn ignition switch OFF.
- Check voltage between driver seat control unit connector and ground.
DRIVER SEAT CONTROL UNIT CONNECTOR AND GROUNDConnector Terminals Condition Voltage (V) (Approx.) (+) (-) P2 13 Ground Lifting switch (front) ON (DOWN operation) 0 Other than above Battery voltage 28 Lifting switch (front) ON (UP operation) 0 Other than above Battery voltage Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
OK : Lifting switch (front) circuit is OK.
NG : GO TO 2.
- CHECK LIFTING SWITCH (FRONT) CIRCUIT HARNESS CONTINUITY
- Disconnect driver seat control unit and power seat switch LH.
- Check continuity between driver seat control unit connector P2 terminals 13, 28 and power seat switch LH connector P8 terminals 5, 6.
13 - 5 : Continuity should exist.
28 - 6 : Continuity should exist.
- Check continuity between driver seat control unit connector P2 terminals 13, 28 and ground
13 - Ground : Continuity should not exist.
28 - Ground : Continuity should not exist.
Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
OK : GO TO 3.
NG : Repair or replace harness.
- CHECK LIFTING SWITCH (FRONT)
Check continuity between power seat switch LH as follows.
LIFTING SWITCH (FRONT)Terminals Condition Continuity 5 3 Lifting switch (front) ON (DOWN operation) Yes Other than above No 6 Lifting switch (front) ON (UP operation) Yes Other than above No