Inspection After Installation
WARNING: This page is about a different car, the 2006 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- Before starting the engine, check oil/fluid levels including engine coolant and engine oil. If the levels are lower than required quantity, fill to the specified level. Refer to "FLUIDS AND LUBRICANTS ".
- Use procedure below to check for fuel leakage.
- Turn ignition switch ON (with engine stopped). With fuel pressure applied to the fuel piping, check for fuel leakage at the connection points.
- Start engine. With engine speed increased, check again for fuel leakage at connection points.
- Run engine to check for unusual noise and vibration.
- Warm up engine thoroughly to make sure there is no leakage of fuel, exhaust gas, or any oils/fluids including engine oil and engine coolant.
- Bleed air from passages in lines and hoses, such as in cooling system.
- After cooling down the engine, again check oil/fluid levels including engine oil and engine coolant. Refill to specified level if necessary.
- Summary of the inspection items:
ITEM REFERENCE
| Item | Before starting engine | Engine running | After engine stopped | ||
|---|---|---|---|---|---|
| Engine coolant | Level | Leakage | Level | ||
| Engine oil | Level | Leakage | Level | ||
| Other oils and fluids(1) | Level | Leakage | Level | ||
| Fuel | Leakage | Leakage | Leakage | ||
| Exhaust gas | - | Leakage | - | ||
|
|||||