LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1612 (Front Axle) >> Drive Shaft >> Disassembly and Assembly >> Disassembly >> Wheel Side

Wheel Side

WARNING: This page is about a different car, the 2005 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mount the drive shaft in a vise.
    CAUTION: When mounting the drive shaft in a vise, use copper or aluminum plates between the vise and the drive shaft.
  2. Remove the boot bands and slide the boot back.
  3. Screw a sliding hammer or suitable tool 30 mm (1.18 in) or more into threaded part of joint sub-assembly. Pull joint sub-assembly off of shaft as shown.
    NOTE: Align the sliding hammer and shaft and remove the joint subassembly by pulling directly.
    CAUTION:
    • If the joint sub-assembly cannot be removed after five or more unsuccessful attempts, replace the entire drive shaft assembly.
      Fig 1: Pulling Joint Sub-Assembly Off Of Shaft
      G03595923Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove boot from the shaft.
  5. Remove circlip from the shaft.
  6. While rotating the ball cage, clean the old grease off of the joint sub-assembly using paper towels.
scientia non olet · About LEMON Manuals