LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1580 (Brake System) >> Rear Disc Brake >> Disassembly and Assembly of Brake Caliper Assembly >> Assembly

Disassembly and Assembly of Brake Caliper Assembly: Assembly

WARNING: This page is about a different car, the 2005 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not use NISSAN Rubber Grease (KRE00 00010, KRE00 00010 01) when assembling.
  1. Apply clean brake fluid to new piston seal and insert in to groove on cylinder body.
    CAUTION: Do not reuse piston seal.
    Fig 1: Applying Clean Brake Fluid To Piston Seal
    G03596083Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Apply brake fluid to piston and to piston boot, then install piston boot in to piston groove.
    CAUTION: Do not reuse piston boot.
    Fig 2: Applying Brake Fluid To Piston
    G03596084Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Insert into cylinder body by hand and insert piston boot piston-side lip into piston groove.
    CAUTION: Press piston evenly and vary the pressing point to prevent cylinder inner wall from being rubbed.
  4. Install sliding boots and sleeves to cylinder body.
scientia non olet · About LEMON Manuals