LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1580 (Brake System) >> Brake Booster >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen lock nut to adjust input rod length so that the length "B" (in the figure) satisfies the specified value.

    Length "B": 150 mm (5.91 in) 

  2. After adjusting "B", temporarily tighten lock nut and install booster assembly to the vehicle.
    • Install a gaskets and spacer block between booster assembly and the dash panel.
  3. Connect brake pedal with clevis of input rod.
  4. Install brake booster mounting nuts and tighten them to the specified torque.
    Fig 1: Loosening Input Rod Lock Nut
    G03596062Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Install brake piping from brake master cylinder to actuator and electric unit. Refer to "HYDRAULIC CIRCUIT ".
  6. Connect vacuum hose to brake booster.
  7. Install master cylinder to booster assembly. Refer to "REMOVAL AND INSTALLATION ".
  8. Adjust the brake pedal height. Refer to "INSPECTION AND ADJUSTMENT ".
  9. Tighten lock nut of input rod to the specified torque.
  10. Refill new brake fluid and bleed air. Refer to "BLEEDING BRAKE SYSTEM ".
scientia non olet · About LEMON Manuals