Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.

Remove wheel sensor mounting screw(s).
- When removing the front wheel sensor, first remove the disc rotor to gain access to the front wheel sensor mounting bolt. Refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND DISC ROTOR ".
Pull out the sensor, being careful to turn it as little as possible.
CAUTION:
- Be careful not to damage sensor edge and sensor rotor teeth.
- Do not pull on the sensor harness.
Disconnect wheel sensor harness electrical connector, then remove harness from mounts.