LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1451 (Roof) >> Soft Top >> Roll Bar Interference Prevention Switch Check (Open Operate)

Roll Bar Interference Prevention Switch Check (Open Operate)

WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK ROLL BAR INTERFERENCE PREVENTION SWITCH SIGNAL 
    1. Start engine.
    2. Operate soft top switch OPEN, check voltage between Soft Top Control Unit Connector and ground.
    Fig 1: Soft Top Control Unit Connector Terminal 22 & Ground Continuity Specifications Table
    G02404854Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    • OK: Roll bar interference prevention switch is OK.
    • NG: GO TO 2.
    Fig 2: Soft Top Control Unit Connector Terminal 22 & Ground Continuity Test
    G02404855Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK ROLL BAR INTERFERENCE PREVENTION SWITCH CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect soft top control unit and soft top switch assembly 2 (roll bar interference prevention switch) connector.
    3. Check continuity between Soft Top Control Unit Connector B67 terminal 22 and soft top switch assembly 2 connector B213 terminal 3.
      • 22 (W/R) - 3 (W/R): Continuity should exist. 
    4. Check continuity between Soft Top Control Unit Connector B67 terminal 22 and ground.
      • 22 (W/R) - Ground: Continuity should not exist. 

    OK or NG 

    • OK: GO TO 3.
    • NG: Repair or replace harness.
    Fig 3: Soft Top Control Unit Connector Terminal 22 & Soft Top Switch Assembly 2 Connector Terminal 3 & Ground Continuity Test
    G02404856Courtesy of NISSAN MOTOR CO., U.S.A.
  3. CHECK ROLL BAR INTERFERENCE PREVENTION SWITCH GROUND CIRCUIT 

    Check continuity between soft top switch assembly 2 connector B213 terminal 1 and ground.

    • 1 (B) - Ground: Continuity should exist. 

    OK or NG 

    • OK: GO TO 4.
    • NG: Repair or replace harness.
    Fig 4: Soft Top Switch Assembly 2 Connector Terminal 1 & Ground Continuity Test
    G02404857Courtesy of NISSAN MOTOR CO., U.S.A.
  4. CHECK SOFT TOP CONTROL UNIT OUTPUT SIGNAL 
    1. Connect soft top control unit connector.
    2. Start engine.
    3. Check voltage between Soft Top Control Unit Connector B67 terminal 22 and ground.
      • 22 (W/R) - Ground: Approx. 5V 

    OK or NG 

    • OK: Replace soft top switch assembly 2.
    • NG: Replace soft top control unit.
    Fig 5: Soft Top Control Unit Connector Terminal 22 & Ground Voltage Test
    G02404858Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals