DTC Confirmation Test
WARNING: This page is about a different car, the 2003 Infiniti Q45. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before performing the following procedure, confirm that battery voltage is more than 10 volts at idle.
- Turn ignition on.
- Select DATA MONITOR mode with scan tool.
- Turn ignition off, then wait at least 10 seconds.
- Turn ignition on.
- Repeat steps 3 and 4 a total of 32 times.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.