LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R Spec V >> Repair and Diagnosis >> Transmission >> Clutch System - RS6F51H >> Piping >> Installation

Clutch System - RS6F51H: Piping: Installation

  1. When installing the clutch hose into the bracket, position the lock plate in the specified direction as shown to secure the clutch hose.
    CAUTION: Install the clutch hose without twisting or bending it.
  2. Tighten the flare nut to specification, using a flare nut wrench.

    Flare nut: 15 -18 N-m (1.5 -1.8 kg-m, 11 -13 ft-lb) 

    Fig 1: Installing Lock Plate For Securing Clutch Hose
    G00777172Courtesy of NISSAN MOTOR CO., U.S.A.
    CAUTION: Be careful not to damage the flare nut and clutch tube.
  3. Position the clutch hose and install the union bolt and two new copper washers on to the operating cylinder, and tighten the union bolt to specification.

    Union bolt: 17 -19 N-m (1.7 - 2.0 kg-m, 13-14 ft-lb) 

  4. Bleed the air from the clutch hydraulic system. Refer to . "BLEEDING PROCEDURE ".
  5. Install the engine air cleaner and air duct.
scientia non olet · About LEMON Manuals