LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R Spec V >> Repair and Diagnosis >> External Pages >> Different car >> Section 2033 (Front Axle) >> Front Drive Shaft >> Disassembly and Assembly (Left Side) >> Assembly >> Transaxle Side

Transaxle Side

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new boot and new small boot band on shaft.
    CAUTION:
    • Cover drive shaft serration with tape to prevent damage to boot during installation.
  2. Remove protective tape wound around serrated part of shaft.
    Fig 1: Covering Drive Shaft Serration With Tape
    G04876506Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Install spider assembly securely, making sure the matching marks which were made during disassembly are properly aligned.
  4. Install new snap ring using a suitable tool.
  5. Pack drive shaft with specified amount of new grease (Genuine NISSAN Grease or equivalent).

    Grease amount : 134 - 144 g (4.73 - 5.08 oz.) 

    Fig 2: Removing/Installing Snap Ring
    G04889265Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Install new stopper ring to housing of slide joint assembly.
  7. After installation, pull shaft to check engagement between slide joint assembly and stopper ring.
  8. Install boot securely into grooves (indicated by * marks) as shown in illustration.
    CAUTION: If there is grease on boot mounting surfaces (indicated by * marks) of shaft and housing, boot may come off. Clean all grease from surfaces.
    Fig 3: Identifying Boot Installation Length
    G04889266Courtesy of NISSAN MOTOR CO., U.S.A.
  9. Make sure boot installation length "L" is the length specified below. Insert a flat-bladed screwdriver or similar tool into the large end of boot. Bleed air from boot to prevent boot deformation.

    Boot installation length "L " : 167.9 mm (6.61 in) 

    CAUTION:
    • Boot may break if boot installation length is less than standard value.
    • Be careful that screwdriver tip does not contact inside surface of boot.
  10. Secure large and small ends of boot with new boot bands as shown in illustration.
    CAUTION: Discard old boot bands and replace with new ones.
    Fig 4: Identifying Boot Bands
    G04876510Courtesy of NISSAN MOTOR CO., U.S.A.
  11. Install new dust shield to slide joint housing.
  12. After installing housing and shaft, make sure boot position is correct. If boot position is not correct, remove old boot bands then reposition the boot and secure with new boot bands.
scientia non olet · About LEMON Manuals