Automatic Operation

WARNING: This page is about a different car, the 2006 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

AUTOMATIC OPERATION TABLE

Function	Description
Memory switch operation	The seat, steering move to the stored driving position by pushing memory switch (1 or 2).
Keyfob interlock operation	Perform memory operation by pressing keyfob unlock button or driver side door request switch.

NOTE:

Disconnecting the battery erases the stored memory.
After connecting the battery, insert the key into the ignition cylinder and turn the driver door switch ON (open)-->OFF (close)-->ON (open), the memory becomes possible.

AUTOMATIC OPERATION TABLE

Auto operation temporary stop conditions.	When ignition switch turned to START position. (With A/T)
Auto operation stop conditions.	When ignition switch turned to START position. (With M/T) When the vehicle speed becomes 7 km/h (4 MPH) or higher. When the setting switch, memory switch 1, or 2 are pressed. When A/T selector lever is in any position other than P. (With A/T) When the parking brake switch is in the released (With M/T) When power seat switch turned ON. When ADP steering switch turned ON (telescopic operation or tilt operation). When the tilt and telescopic sensor malfunction is detected. When the driver's seatback fold down.

Auto operation temporary stop conditions.

When ignition switch turned to START position. (With A/T)

Auto operation stop conditions.

When ignition switch turned to START position. (With M/T)
When the vehicle speed becomes 7 km/h (4 MPH) or higher.
When the setting switch, memory switch 1, or 2 are pressed.
When A/T selector lever is in any position other than P. (With A/T)
When the parking brake switch is in the released (With M/T)
When power seat switch turned ON.
When ADP steering switch turned ON (telescopic operation or tilt operation).
When the tilt and telescopic sensor malfunction is detected.
When the driver's seatback fold down.

NOTE: During automatic operation, if the ignition switch is turned ON-->START, the automatic operation is suspended. When the ignition switch returns to ON, it resumes.