LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R Spec V >> Repair and Diagnosis >> External Pages >> Different car >> Section 1404 (Brake Control System) >> Wheel Sensors >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Infiniti FX45 and 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect wheel sensor connector.
  2. Remove wheel sensor mounting bolts, grommets (front sensor) and clip.
  3. Remove wheel sensor.
CAUTION: Be careful of the following when installing sensor.
  • As much as possible, avoid rotating sensor when removing it. Pull sensors out without pulling on sensor harness. 
  • Take care to avoid damaging sensor edges or rotor teeth. Remove wheel sensor first before removing front wheel hub and bearing assembly and rear final drive. This is to avoid damage to sensor wiring and loss of sensor function. 
scientia non olet · About LEMON Manuals