With Consult-II

Start engine and warm it up to normal operating temperature.
Stop engine and wait at least 5 seconds.
Turn ignition switch ON and select "HO2S1 (B1)/(B2) P1144/P1164" of "HO2S1" in "DTC WORK SUPPORT" mode with CONSULT-II.
Touch "START".
Start engine and let it idle for at least 3 minutes.

Fig 1: Speed Specifications Chart
Courtesy of NISSAN MOTOR CO., U.S.A.

NOTE: Never raise engine speed above 3,600 RPM after this step. If the engine speed limit is exceeded, return to step 5.

Fig 2: Display CONSULT-II (OUTPUT OF CONDITION)
Courtesy of NISSAN MOTOR CO., U.S.A.
When the following conditions are met, "TESTING" will be displayed on the CONSULT-II screen. Maintain the conditions continuously until "TESTING" changes to "COMPLETED". (It will take approximately 50 seconds or more.)

Fig 3: Display CONSULT-II (TESTING)
Courtesy of NISSAN MOTOR CO., U.S.A.

If "TESTING" is not displayed after 5 minutes, retry from step 2.
Make sure that "OK" is displayed after touching "SELF-DIAG RESULTS". If "NG" is displayed, refer to "DIAGNOSTIC PROCEDURE " .

Fig 4: Display CONSULT-II (COMPLETED)
Courtesy of NISSAN MOTOR CO., U.S.A.