Testing Condition:

Before performing the following procedure, confirm that battery voltage is more than 10V at idle.
This test may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.

Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.

Fig 1: Scan Tool Display - Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.
Start engine and maintain the following conditions for at least 5 consecutive seconds.

Fig 2: VHCL Speed SE Chart
Courtesy of NISSAN MOTOR CO., U.S.A.
If DTC is detected, go to DIAGNOSTIC PROCEDURE .