LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Frontier Base, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control System - KA24DE >> DTC P0102, P0103: MAF Sensor >> DTC Confirmation Procedure >> Procedure For DTC P0103 >> With CONSULT-II

With CONSULT-II

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
    Fig 1: Scan Tool Display - Data Monitor
    G00856992Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Wait at least 6 seconds.
  4. If DTC is detected, go to  7 under "DIAGNOSTIC PROCEDURE".

    If DTC is not detected, go to next step.

  5. Start engine and let it idle for at least 6 seconds.
  6. If DTC is detected, go to DIAGNOSTIC PROCEDURE .
scientia non olet · About LEMON Manuals