DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 5 seconds before conducting the next test.

WITH CONSULT-II

Turn ignition switch ON.
Select "DATA MONITOR" mode with CONSULT-II.
Wait at least 5 seconds.
If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

Fig 1: Reading "MONITOR" In "DATA MONITOR" Mode

Courtesy of NISSAN MOTOR CO., U.S.A.

WITH GST

Follow the procedure "WITH CONSULT-II" above.