With Consult-II

Start engine and warm it up to normal operating temperature.
Select "CLSD THL/P SW" in "DATA MONITOR" mode with CONSULT-II and check the indication under the following conditions.

Fig 1: Scan Tool Display - Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Signal Condition Chart
Courtesy of NISSAN MOTOR CO., U.S.A.

If the result is NG, go to "DIAGNOSTIC PROCEDURE ".

If OK, go to following step.
Drive the vehicle for at least 5 consecutive seconds under the following condition.

Fig 3: Throttle Position Chart
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 4: Scan Tool Display - Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.
If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".