DTC Confirmation Procedure: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
- If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- If the target idle speed is out of the specified value, perform " IDLE AIR VOLUME LEARNING ", before conducting "DTC Confirmation Procedure". For the target idle speed, refer to the " SERVICE DATA AND SPECIFICATIONS (SDS) ".
TESTING CONDITION:
- Before performing the following procedure, confirm that battery voltage is more than 11V at idle.
- Always perform the test at a temperature above -10°C (14°F).