LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 524 (Engine Control System - Sedan) >> DTC P0181: FTT Sensor >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2005 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Wait at least 10 seconds.

    If the result is NG, go to "Diagnostic Procedure ".

    If the result is OK, go to following step.

  4. Check "COOLAN TEMP/S" value.

    If "COOLAN TEMP/S" is less than 60°C (140°F), the result will be OK.

    If "COOLAN TEMP/S" is above 60°C (140°F), go to the following step.

  5. Cool engine down until "COOLAN TEMP/S" is less than 60°C (140°F).
  6. Wait at least 10 seconds.
  7. If 1st trip DTC is detected, go to "Diagnostic Procedure ".
    Fig 1: Locating Data Monitor Display Screen
    G02348491Courtesy of NISSAN MOTOR CO., U.S.A.