Mirror Motor RH Circuit Check

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DOOR MIRROR RH MECHANISM
Check the following items.

Operation malfunction caused by a foreign object caught in door mirror face edge.

OK or NG

OK: GO TO 2.

NG: Repair the malfunctioning parts, and check the symptom again.

CHECK FUNCTION

With CONSULT-II

Check the operation with "MIRROR MOTOR RH" in the ACTIVE TEST.

ACTIVE TEST REFERENCE

Test item	Description
MIRROR MOTOR RH	The mirror motor RH moves the mirror UP/DOWN and LEFT/RIGHT by receiving the drive signal.

Without CONSULT-II

GO TO 3.

OK or NG

OK: Mirror motor RH circuit is OK.

NG: GO TO 3.

Fig 1: CONSULT II Display - ACTIVE TEST

Courtesy of NISSAN MOTOR CO., U.S.A.

CHECK DOOR MIRROR RH CIRCUIT HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit and door mirror RH connector.
3. Check continuity between automatic drive positioner control unit connector M41 terminals 14, 15, 30 and door mirror RH connector D113 terminals 9, 10, 11.
  14 - 10 : Continuity should exist.
  
  15 - 9 : Continuity should exist.
  
  30 - 11 : Continuity should exist.
4. Check continuity between automatic drive positioner control unit connector M41 terminals 14, 15, 30 and ground.
  14 - Ground : Continuity should not exist.
  
  15 - Ground : Continuity should not exist.
  
  30 - Ground : Continuity should not exist.
OK or NG

OK: GO TO 4.

NG: Repair or replace harness.

Fig 2: Checking Continuity Between Automatic Drive Positioner Control Unit Connector M41 Terminals 14, 15, 30 And Ground, And Between Connector M41 Terminals 14, 15, 30 And Door Mirror RH Connector D113 Terminals 9, 10, 11
Courtesy of NISSAN MOTOR CO., U.S.A.

CHECK MIRROR MOTOR SIGNAL

Connect the automatic drive positioner control unit and door mirror RH.
Turn ignition switch to ACC.

Check voltage between door mirror RH connector and ground.

TERMINALS VOLTAGE CHART

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
D113	10	Ground	Mirror motor is operated UP	1.7 - Battery voltage
	10		Other than above	0
	9		Mirror motor is operated LEFT	1.7 - Battery voltage
	9		Other than above	0
	11		Mirror motor is operated DOWN or RIGHT	1.7 - Battery voltage
	11		Other than above	0

OK or NG

OK: Replace door mirror motor RH. Refer to "DOOR MIRROR ASSEMBLY ".

NG: Repair or replace harness.

Fig 3: Checking Voltage Between Door Mirror RH Connector D11 Terminals 9, 10 & 11 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.