Runout Inspection
WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Using wheel nuts, secure disc rotor to the wheel hub. (2 or more positions)
- Inspect runout using a dial gauge.
Measurement position : At a point 10 mm (0.39 in) from outer edge of the disc.
Runout limit (with it attached to the vehicle) : 0.05 mm (0.0020 in) or less
CAUTION: Before measuring, make sure the axle end play is 0 mm (0 in). Refer to "ON-VEHICLE INSPECTION AND SERVICE ". - If runout is outside the limit, find the minimum runout point by shifting mounting positions of the disc rotor and wheel hub by one hole.