LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2060 (Rear Axle) >> Wheel Hub >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear wheel and tire using power tool.
  2. Reposition the cylinder body assembly out of the way using a suitable wire without disconnecting the hydraulic hose. Refer to "REMOVAL AND INSTALLATION OF CALIPER ASSEMBLY AND DISC ROTOR ".
    • The brake hose should not be disconnected from the cylinder body.
    • Suspend the cylinder body assembly using a suitable wire so that the brake hose is not stretched.
    CAUTION:
    • Do not depress brake pedal, piston will pop out with cylinder body removed.
    • Do not twist the brake hose.
  3. Remove the brake rotor.
    NOTE: The parking brake must be fully released.
  4. Remove the rear ABS sensor, then position it away from the hub assembly using wire. Refer to "WHEEL SENSORS " (TCS/ABS), "WHEEL SENSORS " (VDC/TCS/ABS).
    CAUTION:
    • Failure to remove the rear ABS sensor may result in damage to the sensor, causing the sensor to become inoperative.
    • Do not stretch the rear ABS sensor wire harness.
  5. Remove the wheel hub assembly from the knuckle using power tool.
scientia non olet · About LEMON Manuals