LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2058 (Automatic Transmission) >> DTC P0500 Vehicle Speed Sensor MTR >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK INPUT SIGNALS 

    With CONSULT-II 

    1. Start engine.
    2. Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-II.
    3. Drive vehicle, and then make sure that the values of "VHCL/S SE-A/T" and "VHCL/S SE-MTR" are same.

    OK or NG 

    OK: GO TO  4.

    NG: GO TO 2.

    Fig 1: CONSULT-II Display DATA MONITOR Screen
    G04906049Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK DTC WITH ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) 

    Refer to "TROUBLE DIAGNOSIS " (with TCS/ABS) or "TROUBLE DIAGNOSIS " (with VDC/TCS/ABS).

    OK or NG 

    OK: GO TO 3.

    NG: If NG, recheck pin terminals for damage or loose connection with harness connector.

  3. CHECK DTC WITH COMBINATION METER 

    Refer to "COMBINATION METERS ".

    OK or NG 

    OK: GO TO 4.

    NG: If NG, recheck pin terminals for damage or loose connection with harness connector.

  4. CHECK DTC 

    Perform "DTC Confirmation Procedure". Refer to "DTC CONFIRMATION PROCEDURE ".

    OK or NG 

    OK: INSPECTION END 

    NG: GO TO 5.

  5. CHECK TCM 
    1. Check TCM input/output signal.
    2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.

    OK or NG 

    OK: INSPECTION END 

    NG: Repair or replace damaged parts.

scientia non olet · About LEMON Manuals