LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2037 (Front Axle) >> Drive Shaft >> Disassembly and Assembly >> Assembly >> Final Drive Side

Final Drive Side

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Wrap the serrated part of the shaft with tape. Install the boot band and boot to shaft.
    NOTE: Discard the old boot band and boot and use a new one for assembly.
    Fig 1: Covering Drive Shaft Serration With Tape
    G04876506
  2. Remove the tape wound around the serrated part of the shaft.
  3. Install the ball cage, steel ball, and inner race assembly on the shaft, and secure them using the snap ring.
    NOTE: Discard the old snap ring and use a new one for assembly.
    Fig 2: Identifying Ball Cage
    G04876507
  4. Insert the specified quantity of Genuine NISSAN Grease or equivalent, into the housing (indicated by * marks), and install it onto shaft. Refer to "RECOMMENDED FLUIDS AND LUBRICANTS ".

    Grease capacity : 120 - 140 g (4.23 - 4.94 oz) 

    Fig 3: Identifying Grease Applying Area
    G04899092
  5. Install the stopper ring onto the housing.
    CAUTION:
    • Do not reuse stopper rings.
    • Make sure that housing and stopper ring are fully engaged.
  6. Install the boot securely into the grooves (indicated by * marks) as shown.
    CAUTION: If there is grease on boot mounting surfaces (indicated by * marks) of shaft and housing, boot may come off. Remove all grease from surfaces.
    Fig 4: Inserting Flat-Tipped Screwdriver Into Large End Of Boot To Bleed Air From Boot
    G04899093
  7. Check that the boot installation length "L" is the length indicated below. Insert a flat-tip screwdriver or similar tool into the large side of boot. Bleed air from boot to prevent boot deformation.

    Boot installation length "L " : 163.9 - 164.3 mm (6.45 - 6.47 in) 

    CAUTION:
    • The boot may break if the boot installation length is less than the specified value.
    • Do not to touch the tip of the screwdriver to the inside of the boot.
  8. Secure the big and small ends of the boot with the new boot bands as shown.
    NOTE: Discard not reuse boot bands.
    Fig 5: Identifying Boot Bands
    G04876510
  9. Secure housing and shaft and then make sure that they are in the correct position when rotating boot. Use a new boot band if the boot band needs to be loosened to reposition the boot.
  10. Install circlip and dust cover to housing.
    NOTE: Do not reuse circlip and dust cover.
scientia non olet · About LEMON Manuals