LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2006 (Seats) >> Automatic Drive Positioner >> Mirror Motor LH Circuit Check

Mirror Motor LH Circuit Check

WARNING: This page is about a different car, the 2006 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DOOR MIRROR LH MECHANISM 

    Check the following items.

    Operation malfunction caused by a foreign object caught in door mirror face edge.

    OK or NG 

    OK : GO TO 2.

    NG : Repair the malfunctioning parts, and check the symptom again.

  2. CHECK FUNCTION 

    With CONSULT-II 

    Check the operation with "MIRROR MOTOR LH" in the ACTIVE TEST.

    CONSULT-II FUNCTION

    Test item Description
    MIRROR MOTOR LH The mirror motor LH moves the mirror UP/DOWN and LEFT/RIGHT by receiving the drive signal.

    Without CONSULT-II 

    GO TO 3.

    OK or NG 

    OK : Mirror motor LH circuit is OK.

    NG : GO TO 3.

    Fig 1: CONSULT-II Display - ACTIVE TEST
    G04756506
  3. CHECK DOOR MIRROR MOTOR LH CIRCUIT HARNESS CONTINUITY 
    1. Turn ignition switch OFF.
    2. Disconnect automatic drive positioner control unit and door mirror LH.
    3. Check continuity between automatic drive positioner control unit connector M33 terminals 16, 31, 32 and door mirror LH connector D4 terminals 1, 2, 3.

      16 - 3 : Continuity should exist. 

      31 - 1 : Continuity should exist. 

      32 - 2 : Continuity should exist. 

    4. Check continuity between automatic drive positioner control unit connector M33 terminals 16, 31, 32 and ground.

      16 - Ground : Continuity should not exist. 

      31 - Ground : Continuity should not exist. 

      32 - Ground : Continuity should not exist. 

      Fig 2: Identifying Door Mirror Motor LH Circuit Harness Continuity
      G04756507

    OK or NG 

    OK : GO TO 4.

    NG : Repair or replace harness.

  4. CHECK MIRROR MOTOR SIGNAL 
    1. Turn ignition switch to ACC.
    2. Check voltage between door mirror LH connector and ground.
      VOLTAGE SPECIFICATIONS

      Connector Terminals Condition Voltage (V) (Approx.)
      (+) (-)
      D4 1 Ground When motor is operated UP 1.5 - Battery voltage
      Other than above 0
      2 When motor is operated LEFT 1.5 - Battery voltage
      Other than above 0
      3 When motor is operated
      DOWN or RIGHT      		 1.5 - Battery voltage
      Other than above 0
      Fig 3: Identifying Voltage Between Door Mirror LH Connector And Ground
      G04756508

    OK or NG 

    OK : Replace door mirror LH. Refer to DOOR MIRROR ASSEMBLY .

    NG : Repair or replace harness.

scientia non olet · About LEMON Manuals