LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1718 (Front Axle) >> Drive Shaft >> Disassembly and Assembly >> Disassembly >> Final Drive Side

Final Drive Side

WARNING: This page is about a different car, the 2006 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mount the drive shaft in a vise.
    CAUTION: When mounting the drive shaft in a vise, use copper or aluminum plates between the vise and the drive shaft.
  2. Remove boot bands and slide the boot back.
  3. Put matching marks on housing and shaft before separating joint assembly.
    CAUTION: Use paint or similar substance for matching marks. Do not scratch the surfaces.
  4. Remove the stopper ring with a flat-bladed screwdriver as shown, and pull the housing off.
    Fig 1: Removing Stopper Ring
    G04175264Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove the snap ring, then remove the ball cage, steel ball, inner race assembly from the shaft.
  6. Remove the boot from the shaft.
  7. Remove circlip and dust cover from housing.
  8. Clean the old grease off of the housing using paper towels.
    Fig 2: Removing Snap Ring
    G04175265Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals