LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 366 (Propeller Shaft) >> Rear Propeller Shaft >> Disassembly And Assembly >> Journal Disassembly

Journal Disassembly

WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the propeller shaft assembly from the vehicle. Refer to REMOVAL AND INSTALLATION .
  2. Put matching marks on the rear propeller shaft tube and flange yoke as shown.
    CAUTION: For matching marks use paint. Never damage the rear propeller shaft or flange yoke.
    Fig 1: Putting Matching Marks On The Rear Propeller Shaft Tube And Flange Yoke
    G00728474Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Remove the snap rings.
    Fig 2: Removing The Snap Rings
    G00728475Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Push out and remove the journal bearing by lightly tapping the yoke with a hammer, taking care not to damage the journal or yoke hole.
    Fig 3: Removing The Journal Bearing
    G00728476Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove the bearing at the opposite side of above operation.
    NOTE: Put marks on the disassembled parts so that they can be reinstalled in their original positions from which they were removed.
Fig 4: Removing The Bearing At The Opposite Side
G00728477Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals