Runout Inspection
WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Using wheel nuts, secure disc rotor to the wheel hub in 2 or more positions.
- Inspect runout using a dial gauge.
Measurement point : At a point 10 mm (0.39 in) from outer edge of the disc
Maximum runout (with it attached to the vehicle) : 0.04 mm (0.0016 in) or less
CAUTION: Before measuring, make sure the axle end play is 0 mm (0 in). Refer to "FRONT WHEEL BEARING ". - If runout is outside the limit, find the minimum runout point by shifting mounting positions of the disc rotor and wheel hub by one hole.