LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2059 (Front Axle) >> Front Drive Shaft >> Disassembly and Assembly (Left Side) >> Disassembly >> Wheel Side

Wheel Side

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mount the front drive shaft in a vise.
    CAUTION: When mounting shaft in a vise, always use copper or aluminum plates between vise and shaft.
  2. Remove boot bands and slide the boot back.
  3. Screw a sliding hammer or suitable tool 30 mm (1.18 in) or more into threaded part of joint sub-assembly. Pull joint sub-assembly out of shaft.
    CAUTION:
    • Align sliding hammer or suitable tool and drive shaft then remove joint sub-assembly by pulling directly.
    • If joint sub-assembly cannot be removed after five or more unsuccessful attempts, replace the entire drive shaft assembly.
    Fig 1: Pulling Joint Sub Assembly
    G04876504Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove boot from shaft.
  5. Remove circlip from shaft.
  6. While rotating ball cage, clean the old grease off of the joint sub-assembly.
scientia non olet · About LEMON Manuals