Cornering Lamp Does Not Operate

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE TEST
With CONSULT-II
1. Select "IPDM E/R" on CONSULT-II, and select "ACTIVE TEST" on "SELECT DIAG MODE" screen.
2. Select "CORNERING LAMP" during active test.
  
  Fig 1: Displaying CORNERING LAMP On ACTIVE TEST Screen
  Courtesy of NISSAN MOTOR CO., U.S.A.
3. Select "RH", then "LH" on "ACTIVE TEST" screen.
4. Make sure cornering lamp LH and cornering lamp RH operate.
Without CONSULT-II

GO TO 3.

OK or NG
- OK: GO TO 2.
- NG: GO TO 3.
CHECK COMBINATION SWITCH INPUT SIGNAL
1. Select "IPDM E/R" on CONSULT-II, and select "DATA MONITOR" on "SELECT DIAG MODE" screen.
2. Make sure "CRNRNG LMP REQ" turns ON-OFF linked with operation of lighting switch.
  
  Fig 2: Displaying CRNRNG LMP REQ On DATA MONITOR Mode
  Courtesy of NISSAN MOTOR CO., U.S.A.
NOTE: Lighting switch must not be in OFF position.

When lighting switch is in TURN RH position: CRNRNG LMP REQ R

When lighting switch is in TURN LH position: CRNRNG LMP REQ L

OK or NG
- OK: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".
- NG: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".
CHECK BULB
Check bulb standard of each cornering lamp is correct. Refer to "EXTERIOR LAMP ".

OK or NG
- OK: GO TO 4.
- NG: Replace cornering lamp bulb. Refer to "BULB REPLACEMENT ".
CHECK CORNERING LAMPS CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connectors and cornering lamp LH and RH connectors.
3. Check continuity between IPDM E/R harness connector E122 terminal 23 (W/L) and cornering lamp RH harness connector E137 terminal + (W/L).
  
  Fig 3: Checking Continuity Between IPDM E/R Harness Connector E124 Terminal 34 & Front Cornering Lamp LH Harness Connector E43 Terminal +
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  + (W/L) - 23 (W/L): Continuity should exist.
4. Check continuity between IPDM E/R harness connector E124 terminal 34 (W/G) and front cornering lamp LH harness connector E43 terminal + (W/G).
  + (W/G) - 34 (W/G): Continuity should exist.
OK or NG
- OK: GO TO 5.
- NG: Repair harness or connector.
CHECK GROUND
1. Check continuity between cornering lamp LH harness connector E43 terminal - (B) and ground.
  - (B) - Ground: Continuity should exist.
2. Check continuity between cornering lamp RH harness connector E137 terminal - (B) and ground.
  - (B) - Ground: Continuity should exist.
  
  Fig 4: Checking Continuity Between Cornering Lamp LH Harness Connector E43 Terminal - & Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
- OK: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".
- NG: Repair harness or connector.