LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1428 (Brake System) >> Rear Disc Brake >> Removal and Installation of Brake Pad >> Installation

Removal and Installation of Brake Pad: Installation

WARNING: This page is about a different car, the 2005 Infiniti FX45 and 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply PBC (Poly Butyl Cuprysil) grease or silicon-based grease to the backside of pad and to both sides of shim, and attach inner shim and shim cover to inner pad, and attach the outer shim and outer shim cover to outer pad.
  2. Install pad retainer and mount pad to torque member.
  3. Push piston in so that pad is firmly attached and mount cylinder body to torque member.
    NOTE: Using a disc brake piston tool (commercial service tool), makes it easier to push in piston.
    CAUTION: By pushing in piston, brake fluid returns to master cylinder reservoir tank. Watch the level of the surface of reservoir tank.
  4. Install sliding pin bolt (one on top) and tighten to the specified torque.
  5. Check brake for drag.
  6. Install tires to the vehicle.
scientia non olet · About LEMON Manuals