LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1415 (Engine Control System - VQ35DE) >> DTC P0500: VSS >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine (TCS switch or VDC switch OFF).
  2. Read "VHCL SPEED SE" in "DATA MONITOR" mode with CONSULT-II. The vehicle speed on CONSULT-II should exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.

    If NG, go to "DIAGNOSTIC PROCEDURE  ".

    If OK, go to following step.

  3. Select "DATA MONITOR" mode with CONSULT-II.
  4. Warm engine up to normal operating temperature.
  5. Maintain the following conditions for at least 60 consecutive seconds.
    CONDITIONS

    ENG SPEED 1,700 - 6,000 rpm
    COOLAN TEMP/S More than 70°C (158°F)
    B/FUEL SCHDL 4.9 - 31.8 msec
    Selector lever Except P or N position
    PW/ST SIGNAL OFF
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE  ".
    Fig 1: Data Monitor Scan Tool Display
    G02360658Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals