Power Supply Circuit Inspection
WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FUSE
- Check that the following fuses of the BOSE speaker amp. and Audio unit are not blown.
FUSE CHECK CHARTUnit Terminals Signal name Fuse No. Audio unit 6 Battery power 38 10 Ignition switch ACC or ON 6 BOSE speaker amp. 1 Battery power 38 OK or NG
- OK: GO TO 2.
- NG: If fuse is blown, be sure to eliminate cause of problem before installing new fuse. Refer to POWER DISTRIBUTION .
- CHECK POWER SUPPLY CIRCUIT
- Check voltage between the audio unit and ground.VOLTAGE CHECK CHART
Unit Terminal No. OFF ACC ON (+) (-) Connector Terminal (Wire color) Audio unit M44 6 (Y) Ground Battery voltage Battery voltage Battery voltage 10 (P/B) Ground 0 V Battery voltage Battery voltage - Check voltage between BOSE speaker amp. and ground.VOLTAGE CHECK CHART
Unit Terminal No. OFF ACC ON (+) (-) Connector Terminal (Wire color) BOSE speaker amp. B114 1 (Y) Ground Battery voltage Battery voltage Battery voltage
OK or NG
- OK:
- INSPECTION END. (Base system)
- GO TO 3. (BOSE system)
- NG:
- Check connector housings for disconnected or loose terminals.
- Repair harness or connector.
- Check voltage between the audio unit and ground.
- CHECK GROUND CIRCUIT
Check continuity between BOSE speaker amp. harness connector B114 terminal 17 (B) and ground.
Continuity should exist.
Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
- OK: INSPECTION END.
- NG:
- Check connector housings for disconnected or loose terminals.
- Repair harness or connector.