LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R Spec V >> Repair and Diagnosis >> External Pages >> Different car >> Section 2084 (LAN System) >> Can >> Trouble Diagnosis >> Combination Meter Branch Line Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK CONNECTOR 
    1. Turn the ignition switch OFF.
    2. Disconnect the battery cable from the negative terminal.
    3. Check the terminals and connectors of the combination meter for damage, bend and loose connection (unit side and connector side).

    OK or NG 

    OK: GO TO 2.

    NG: Repair the terminal and connector.

  2. CHECK HARNESS FOR OPEN CIRCUIT 
    1. Disconnect the connector of combination meter.
    2. Check the resistance between the combination meter harness connector terminals.
      RESISTANCE CHART

      Combination meter harness connector Resistance (Ω)
      Connector No. Terminal No.
      M24 9 11 Approx. 54 - 66

    OK or NG 

    OK: GO TO 3.

    NG: Repair the combination meter branch line.

  3. CHECK POWER SUPPLY AND GROUND CIRCUIT 

    Check the power supply and the ground circuit of the combination meter. Refer to "WIRING DIAGRAM - METER - ".

    OK or NG 

    OK >>

    • Present error: Replace the combination meter. Refer to "COMBINATION METER ".
    • Past error: Error was detected in the combination meter branch line.

    NG: Repair the power supply and the ground circuit.

scientia non olet · About LEMON Manuals