Function and System Application

FUNCTION AND SYSTEM APPLICATION CHART

Diagnostic test mode

Function

ENGINE

TRANSMISSION

ALL MODE 4WD

AIR BAG

METER A/C AMP

BCM

AUTO DRIVE POS.

ABS

ABS (Including VDC)

AIR PRESSURE MONITOR

NVIS (NATS)

Work support

This mode enables a technician to adjust some devices faster and more accurately by following the indications on CONSULT-II. X

⁽¹⁾

Self-diagnostic results

Self-diagnostic results can be read and erased quickly.

⁽¹⁾

Trouble diagnostic record

Current self-diagnostic results and all trouble diagnostic records previously stored can be read.

⁽¹⁾

Data monitor

Input/Output data in the ECM can be read.

⁽¹⁾

Active test

Diagnostic Test Mode in which CONSULT-II drives some actuators apart from the ECMs and also shifts some parameters in a specified range.

⁽¹⁾

DTC confirmation

The results of SRT (System Readiness Test) and the self-diagnosis status/result can be confirmed.

⁽¹⁾

DTC work support

Select the operating condition to confirm Diagnosis Trouble Codes.

⁽¹⁾

ECM part number

ECM part number can be read.

⁽¹⁾

ECU discriminated No.

Classification number of a replacement ECU can be read to prevent an incorrect ECU from being installed.

⁽¹⁾

Function test

Conducted by CONSULT-II instead of a technician to determine whether each system is "OK" or "NG".

⁽¹⁾

Control unit initialization

All registered ignition key IDs in NATS components can be initialized and new IDs can be registered.

⁽¹⁾

CALIB data

Characteristic information for TCM and CVT assembly can be read. Do not use, but displayed.

⁽¹⁾

⁽¹⁾	Applicable