Key Switch (insert) Check

CHECK KEY SWITCH INPUT SIGNAL
Check voltage between BCM harness connector M18 terminal 62 (B/R) and ground.

Fig 1: Checking Key Switch Input Signal (1 Of 2)
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Checking Key Switch Input Signal (2 Of 2)
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG?
1. OK: Key switch is OK.
2. NG: GO TO 2
CHECK KEY SWITCH (INSERT)
Check continuity between key switch connector M26 terminals 3 and 4.

Fig 3: Checking Key Switch (Insert) (1 Of 2)
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 4: Checking Key Switch (Insert) (2 Of 2)
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG?
1. OK: Check the following.
  - 10A fuse [No. 19, located in fuse block (J/B)]
  - Harness for open or short between key switch and fuse
  - Harness for open or short between BCM and key switch
2. NG: Replace key switch.