M/T Model

Power is supplied at all times:

• Through 40A fusible link (letter m  , located in the fuse and fusible link box)
• To ignition switch terminal B.

  With the ignition switch in the START position, power is supplied:

• From ignition switch terminal St.
• To intelligent power distribution module engine room (IPDM E/R) terminal 11.

  With the ignition switch in the ON or START position, power is supplied:

• Through 10A fuse [No. 12, located in the fuse block (J/B)]
• To intelligent power distribution module engine room (IPDM E/R) terminal 43.

  When the clutch pedal is depressed, ground is supplied to intelligent power distribution module engine room (IPDM E/R) terminal 46 through the clutch interlock switch and body grounds E15 and E24.

  Provided that the intelligent power distribution module (IPDM E/R) receives a starter relay on signal from the BCM over the CAN lines, the IPDM E/R is energized and power is supplied:

• From terminal 4 of the clutch interlock relay
• To terminal S of the starter motor windings.

  The starter motor plunger closes and provides a closed circuit between the battery and the starter motor. The starter motor is grounded to the cylinder block. With power and ground supplied, the starter motor operates. In the event that the CAN communication line fails, the IPDM E/R will continue to receive a starter relay on signal from the BCM as long as the ignition switch remains in the START or ON positions.