LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2002 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1924 (Engine Control System (2AZ-FE)) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE FRONT FENDER APRON SEAL RH (See  REMOVAL  ) 
  3. REMOVE FAN AND GENERATOR V BELT (See  REMOVAL  ) 
  4. REMOVE GENERATOR ASSEMBLY (See  REMOVAL  ) 
  5. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the connector clamp.
    3. Remove the wire harness from the wire harness clamp bracket.
    4. Remove the wire harness clamp.
    5. Remove the bolt and sensor.
Fig 1: Disconnecting Sensor Connector
G04221338Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals