Cornering Lamp Does Not Operate

WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE TEST
With CONSULT-II
1. Select "IPDM E/R" on CONSULT-II, and select "ACTIVE TEST" on "SELECT DIAG MODE" screen.
2. Select "CORNERING LAMP" during active test.
3. Select "RH", then "LH" on "ACTIVE TEST" screen.
4. Make sure cornering lamp LH and RH operate.
Without CONSULT-II

GO TO 3.

OK or NG

OK: GO TO 2.

NG: GO TO 3.

Fig 1: CONSULT-II Display Screen - ACTIVE TEST
Courtesy of NISSAN MOTOR CO., U.S.A.
CHECK COMBINATION SWITCH INPUT SIGNAL
1. Select "IPDM E/R" on CONSULT-II, and select "DATA MONITOR" on "SELECT DIAG MODE" screen.
2. Make sure "CRNRNG LMP REQ" turns ON-OFF linked with operation of lighting switch.
  NOTE: Lighting switch must not be in OFF position.
  
  When lighting switch is in TURN RH position: CRNRNG LMP REQ R
  
  When lighting switch is in TURN LH position: CRNRNG LMP REQ L
  
  Fig 2: CONSULT-II Display Screen - DATA MONITOR
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG

OK: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".

NG: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".
CHECK BULB
Check bulb standard of each cornering lamp is correct. Refer to "EXTERIOR LAMP ".

OK or NG

OK: GO TO 4.

NG: Replace cornering lamp bulb. Refer to "BULB REPLACEMENT ".

CHECK CORNERING LAMPS CIRCUIT

Turn ignition switch OFF.
Disconnect IPDM E/R connectors and front combination lamp LH and RH connectors.

Check continuity between IPDM E/R harness connector terminal and front combination lamp harness connector terminal.

Fig 3: Identifying Continuity Between IPDM E/R And Front Combination Lamp Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

IPDM E/R - FRONT COMBINATION LAMP - CONTINUITY TABLE

A			B			Continuity
IPDM E/R connector		Terminal	Front combination lamp connector		Terminal	Continuity
RH	E122	23	RH	E137	7	Yes
LH	E124	34	LH	E43	7	Yes

OK or NG

OK: GO TO 5.

NG: Repair harness or connector.

CHECK GROUND

Check continuity between front combination lamp harness connector terminal and ground.

Fig 4: Identifying Continuity Between Front Combination Lamp Connector Terminal And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

FRONT COMBINATION LAMP - CONTINUITY TABLE

Terminals				Continuity
Front combination lamp connector		Terminal		Continuity
RH	E137	8	Ground	No
LH	E43	8	Ground	No

OK or NG

OK: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".

NG: Repair harness or connector.