Checking And Adjusting: Notes
WARNING: This page is about a different car, the 2005 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
If excessive lubricant leakage is noted, do not perform the lubricant return operation.
Start the engine and set the following conditions:
Test Condition
- Engine speed: Idling to 1, 200 RPM
- A/C switch: On
- Blower speed: Max. position
- Temp. control: Optional [Set so that intake air temperature is 25° to 30° C (77° to 86°F)]
- Intake position: Recirculation ()
- Perform lubricant return operation for about ten minutes
Adjust the lubricant quantity according to the following table.
Lubricant Adjusting Procedure for Components Replacement Except Compressor
After replacing any of the following major components, add the correct amount of lubricant to the system.
Amount of Lubricant to be Added
AMOUNT OF LUBRICANT CHART
| Part replaced | Lubricant to be added to system | Remarks | ||
|---|---|---|---|---|
| Amount of lubricant ml (US fl oz, Imp fl oz) |
||||
| Front evaporator | 75 (2.5, 2.6) | - | ||
| Condenser | 75 (2.5, 2.6) | - | ||
| Liquid tank | 5 (0.2, 0.2) | Add if compressor is not replaced. | ||
| In case of refrigerant leak | 30 (1.0, 1.1) | Large leak | ||
| - | Small leak (1) | |||
|
||||