Consult-II Inspection Procedure

WARNING: This page is about a different car, the 2005 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

Turn ignition switch "OFF".
Connect "CONSULT-II" and CONSULT-II CONVERTER to data link connector.

Fig 1: Locating Hood Opener Handle And Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch "ON".
Touch "START(NISSAN BASED VHCL)".

Fig 2: CONSULT II Engine Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BCM".
If "BCM" is not indicated, go to CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT

Fig 3: Select System Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "REAR DEFOGGER".

Fig 4: Select Test Item Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.
Select diagnosis mode,"DATA MONITOR" and "ACTIVE TEST" are available.

Fig 5: Select Diag Mode Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.