LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2002 >> Sentra SE-R, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1867 (Automatic Transmission) >> Trouble Diagnosis >> CONSULT-II Function (A/T) >> Consult-II Setting Procedure

Consult-II Setting Procedure

WARNING: This page is about a different car, the 2006 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.
Fig 1: Locating Data Link Connector
G04187192Courtesy of NISSAN MOTOR CO., U.S.A.
  1. Turn ignition switch "OFF".
  2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is located in instrument lower panel on driver side.
  3. Turn ignition switch "ON". (Do not start engine.)
  4. Touch "START (NISSAN BASED VHCL)".
    Fig 2: Consult-II Display Screen
    G04151184Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Touch "A/T".

    If "A/T" is not indicated, go to "CONSULT II DATA LINK CONNECTOR (DLC) CIRCUIT ".

  6. Perform each diagnostic test mode according to each service procedure.
Fig 3: Consult-II SELECT SYSTEM Display Screen
G04083859Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals