with CONSULT-II
WARNING: This page is about a different car, the 2006 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch "ON". (Do not start engine.)
- Select "DATA MONITOR" mode for "A/T" with CONSULT-II.
- Drive vehicle and check for an increase of "VHCL/S SE.A/T" value in response to "VHCL/S SE-MTR" value.
If the check result is NG, go to "DIAGNOSTIC PROCEDURE ". If the check result is OK, go to following step.
- Select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
- Start engine and maintain the following conditions for at least 5 consecutive seconds.
VHCL SPEED SE: 30 km/h (19 MPH) or more THRTL POSSEN: More than 1.0/8 Selector lever: "D" position Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test .
If the check result is NG, go to "DIAGNOSTIC PROCEDURE ". If the check result is OK, go to following step.
- Maintain the following conditions for at least 5 consecutive seconds.
ENGINE SPEED: 3,500 RPM or more THRTL POSSEN: More than 1.0/8 Selector lever: "D" position Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test .
If the check result is NG, go to "DIAGNOSTIC PROCEDURE ".