Drive Shaft: Removal

WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

Remove cotter pin and wheel bearing lock nut.

Fig 1: Removing Cotter Pin And Wheel Bearing Lock Nut
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove drive shaft center support bearing bolts.

Fig 2: Removing Drive Shaft Center Support Bearing Bolts
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove strut lower mounting nuts and bolts.
Remove brake hose clip.

Fig 3: Removing Brake Hose Clip
Courtesy of NISSAN MOTOR CO., U.S.A.
Separate drive shaft from knuckle by lightly tapping it. If it is hard to remove, use a puller.
- Cover boots with shop towel so as not to damage them when removing drive shaft.
Fig 4: Removing Drive Shaft
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove left drive shaft from transaxle.

Fig 5: Removing Left Drive Shaft From Transaxle
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove right drive shaft from transaxle.
- For M/T models -
- Pry off drive shaft from transaxle as shown at right.
  
  Fig 6: Removing Right Drive Shaft From Transaxle
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  - For A/T models -
- Insert screwdriver into transaxle opening for right drive shaft and strike with a hammer.
- Be careful not to damage pinion mate shaft and side gear.

Fig 7: Inserting Screwdriver Into Transaxle Opening For Right Drive Shaft

Courtesy of NISSAN MOTOR CO., U.S.A.