CONSULT-II Setting Procedure

WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.

For details, refer to the separate "CONSULT-II Operations Manual".

Turn ignition switch OFF.
Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is located in instrument lower panel on driver side.
Turn ignition switch ON.

Fig 1: Locating Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "START (NISSAN BASED VHCL)".

Fig 2: Selecting "START (NISSAN BASED VHCL)" On CONSULT-II Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "A/T".
If "A/T" is not indicated, go to , " CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT " .
Perform each diagnostic test mode according to each service procedure.