DTC Confirmation Procedure

WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Always drive vehicle at a safe speed.

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

With CONSULT-II:

Start engine.
Accelerate vehicle to maintain the following condition.
1. ACCELE POS: 1.5/8 - 2.0/8
2. Selector lever: "D" position
3. Gear position: 1st --> 2nd Gear (D/C ON/OFF)
Perform step "2" again.
Turn ignition switch OFF, then perform step "1" to "3" again.
Check "SELF-DIAG RESULTS" mode for "A/T" with CONSULT-II.
If DTC (P1845) is detected, go to " DIAGNOSTIC PROCEDURE " .

If DTC (P1762) is detected, go to " DIAGNOSTIC PROCEDURE ". .