LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2002 >> Sentra SE-R Spec V >> Repair and Diagnosis >> External Pages >> Different car >> Section 2380 (Engine Control System - DTCS U0101 To P0183) >> DTC P0125: ECT Sensor >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

WARNING: This page is about a different car, the 2011 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-III.
  3. Check that "COOLAN TEMP/S" is above 20°C (68°F).

    If the temperature is above 20°C (68°F), the test result will be OK. 

    If the temperature is below 20°C (68°F), go to following step. 

  4. Start engine and run it for 65 minutes at idle speed.

    If "COOLAN TEMP/S" increases to more than 20°C (68°F) within 65 minutes, stop engine because the test result will be OK. 

  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".