LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2001 >> Sentra XE, Automatic >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Power Door Locks >> System Tests >> Front Door Switch Check >> Models Without Multi-Remote Control System

Models Without Multi-Remote Control System

  1. Check Left Front Door Switch Input Signal

    Turn ignition off. Measure voltage (backprobe) between ground and terminal No. 7 (Red wire) of 24-pin Time Control Unit (TCU) harness connector M-41. See Figure . See WIRING DIAGRAMS  . Approximately 5 volts should be present with left front door closed, and zero volts with left front door open. If voltage is as specified, go to next step. If voltage is not as specified, go to step  3 .

  2. Check Right Front Door Switch Input Signal

    Measure voltage (backprobe) between ground and terminal No. 9 (Red/White wire) of 24-pin TCU harness connector M-41. See WIRING DIAGRAMS  . Approximately 5 volts should be present with door closed, and zero volts with door open. If voltage is as specified, door switches are okay. If voltage is not as specified, go to next step.

  3. Check Left Front Door Switch

    Turn ignition off. Disconnect door switch harness connectors. Check for continuity between switch terminals No. 2 (Red wire) and 3 (Black wire). Continuity should exist when door is open and not exist when door is closed. If continuity is not as specified, replace door switch. If continuity is as specified, check door switch ground circuit and connection. Check for open or short in Red wire between door switch and terminal No. 7 of 24-pin TCU harness connector M-41. Repair as necessary.

  4. Check Right Front Or Rear Door Switches

    Turn ignition off. Disconnect door switch harness connectors. Check for continuity between ground and right front switch terminal No. 1 (Red/White wire) or rear switch (+) terminal (Red/White wire). Continuity should exist when door is open and not exist when door is closed. If continuity is not as specified, replace door switch. If continuity is as specified, check door switch ground connection. Check for open or short in Red/White wire between appropriate door switch and terminal No. 9 of 24-pin TCU harness connector M-41. Repair as necessary.
scientia non olet · About LEMON Manuals