Cooling System Bleeding: ALTIMA
- On models equipped with automatic A/C, turn ignition off. Turn ignition on, then after 5 seconds, press the hot button 3 times the defrost button 2 times. Climate control panel should display "43", indicating that heater valve is open.
- On models equipped with manual A/C, turn ignition on. Set temperature control to maximum heat position. Wait 10 seconds, then turn ignition off.
- On all models, open air relief plug. See Fig 1
. Fill radiator slowly to allow air to escape. Close air relief valve when coolant starts to flow out of air relief hole. Fill coolant reservoir to MAX mark.
- Reinstall radiator cap. Start and warm engine to normal operating temperature. Race engine 2-3 times under no-load. Turn engine off. Add coolant after engine cools down. Check drain plug and air bleed plug for leaks.
Courtesy of NISSAN MOTOR CO., U.S.A.