LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 1985 >> 300ZX GL, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (EFI Control System) >> Component Testing >> Air Regulator

Air Regulator

WARNING: This page is about a different car, the 1985 Nissan Stanza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect 15-pin connector and check voltage between C and ground when ignition is on. See Fig 1 . If battery voltage is present, test is complete. If not, check harness and repair if necessary.
    Fig 1: EFI 15-Pin Connector
    G50J08072
  2. If okay, check air regulator. Check continuity between regulator connector terminals. Continuity should exist. If not, replace air regulator. Remove air regulator and visually check shutter opening.
  3. When engine is cold, shutter should be open. After warm-up, shutter should be closed. Pry air regulator shutter open with a screwdriver and check to see if shutter opens and closes smoothly. If no good, replace EFI control unit.